Menu
Your Cart

Sonifex RB-MA2 Dual Microphone Amplifier

Sonifex RB-MA2 Dual Microphone Amplifier
Sonifex RB-MA2 Dual Microphone Amplifier
Sonifex RB-MA2 Dual Microphone Amplifier
Sonifex RB-MA2 Dual Microphone Amplifier
Sonifex RB-MA2 Dual Microphone Amplifier
Sonifex RB-MA2 Dual Microphone Amplifier
Sonifex RB-MA2 Dual Microphone Amplifier
$185.00
+ $156.00 Shipping
  • Stock: 1
  • Code: BS17115
  • Model: RB-MA2

The RB-MA2 consists of two independent low-noise microphone pre-amplifiers for converting mic level signals to line level, or for driving long lines from microphones to processing equipment. Sonifex RB-MA2 Dual Microphone Amplifier

All connections and controls are on the rear panel. The microphone inputs are XLR-3 type and are electronically balanced. The input gain for each input can be adjusted individually by a recessed pre-set potentiometer which allows for the use of both dynamic and powered microphones.

The XLR-3 line outputs are electronically balanced and can be wired unbalanced by grounding the non-phase signal, allowing you to feed both balanced and unbalanced equipment.

For each channel there are independent switches to control a high pass filter (low frequency roll-off at 125Hz) and to provide phantom power at +48V to the connected microphones.

Technical Details

Technical Specification For RB-MA2

Audio Specification

Maximum Input Level:-10dBu
Maximum Output Level:+28dBu
Low Frequency Roll-Off:125Hz @ 6dB/octave
E.I.N.:130dB
Common Mode Rejection:>60dB typically
Frequency Response:20Hz to 20kHz ±0.1dB (600Ω load, ref 1kHz)
Input Impedance:2kΩ nominal balanced
Output Impedance:<50Ω
Gain Range:Adjustable 36dB to 75dB gain (each input)
Distortion:0.01% THD @ 1kHz, ref +8dBu output
Phantom Power:48V
  

Connections

Input:2 x XLR 3 pin female (Balanced)
Output:2 x XLR 3 pin male (Balanced, can be unbalanced)
Mains Input:Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max
Fuse Rating:Anti-surge fuse 100mA 20 x 5mm (230VAC)
Anti-surge fuse 250mA 20 x 5mm (115VAC)
  

Equipment Type

RB-MA2:Dual microphone amplifier
  

Physical Specification

Dimensions (Raw):28cm (W) x 10.8cm (D) x 4.2cm (H) (1U)
11” (W) x 4.3” (D) x 1.7” (H) (1U)
Dimensions (Boxed):36cm (W) x 20.5cm (D) x 6cm (H)
14.2” (W) x 8” (D) x 2.4” (H)
Weight:Nett: 1.00kg Gross: 1.45kg
Nett: 2.2lbs  Gross: 3.2lbs